Filter
Top Products
5
Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Description Qty.
Carriage bolts
Shoulder Bolt
Flange nuts
Washer
Knob
Cap Plunger
Chute
Deflector
4
1
4
1
1
1
1
1
Installing the Handle
1. Remove temporary cable ties holding cables at handle
adjustment holes (Figure 2).
2. Release handle adjustment levers on both sides.
3. Lift operator handle up to the desired height, and close
adjustment lever ensuring the positioning pin on the
lower handle engages one of the three holes on the
upper handle (Figure 3).
1. Positioning pin
2. Upper handle adjustment hole
Figure 3
1
2
1. Cable ties 2. Adjustment lever
Figure 2
1
2
Figure 5
1. Rotator cable
2. Wiring harness
3. Cable clip
1
2
3
4. Pull up and push down slightly on the handle to verify
handle is locked into place (Figure 4).
NOTE: If handle feels unsecure with the adjustment levers
closed, tighten adjustment handle nuts until the handle
feels secure.
5. Remove the cardboard from recoil start handle and
feed the recoil rope through the rope guide.
Figure 4
1. Handle
2. Recoil handle
3. Rope guide
4. Adjustment lever nut
3
4
2
1
6. Snap two rotator cables and one wiring harness into
the three cable clips (Figure 5).
ASSEMBLY