Filter
Top Products
7
SERVICE AND MAINTENANCE
BLADE WEAR
Sod cutter blades may wear quickly depending on soil condition. Replace blade when worn to 1 1/2”
(3.8cm) or less. Maintain lower blade surface.
CLEANING AND WASHING
Regular cleaning and washing will prolong the service of your machine.
Note: Use care with power washers to avoid damage to Warning Decals, Operator Instruction
Labels, Bearings, Chain and Engine. Avoid direct spray on these items. DO NOT EXCEED 1000
PSI WATER PRESSURE FOR CLEANING.
ADJUSTING CHAIN TENSION
Upper Chain
• No adjustment is required
Lower Chain
• Remove chain guard
• Tilt the sod cutter forward onto the front weight.
• Tighten the 1/2” lock nut on the chain idler until the #40 chain flexes approximately 1/4” ( 6mm) at
mid span.
• Install chain guard.
• Set sod cutter back to level.
STORAGE
1. Refer to engine manufacturer’s instructions for engine storage information.
2. Clean machine.
3. Cover all scratches with touch up paint.
4. Lubricate according to Lubrication Schedule (see page 6).
5. Lightly oil or mil board paint blade to inhibit rust.
6. Covered or indoor storage is recommended.