Husqvarna RZ46215 Lawn Mower User Manual


 
34
OPERATION
1
2
Moving Machine By Hand
When pushing or pulling the mower, engage the
EZT bypass linkages. The EZT bypass linkages are
located on the rear of the frame, below the rear engine
guard.
1. Raise the deck into the highest cutting position.
2. Engage the parking brake.
3. Pull the EZT bypass linkages up and out of the
keyhole slots. Release the levers with the head
outside the frame and held in the bypass position.
4. To reengage the EZT’s to drive, reverse the above
procedure.
Load the machine into truck or trailer by driving slowly
up the ramps. DO NOT LIFT! The machine is not
intended to be lifted by hand.
WARNING!
Make no adjustments without:
the engine stopped,
the ignition key removed,
the parking brake activated
WARNING!
Use extreme caution when loading the
machine into a truck or trailer using
ramps. There is the possibility of serious
injury or death if the machine falls off the
ramps.
WARNING!
Bypass linkages are located close to the
muffler. To prevent burns, the engine
should be shut off and allowed to cool
before the bypass linkage levers are
handled.
8058-150
Bypass linkages
8058-033
1. EZT engaged
2. EZT locked in the bypass
Bypass linkage - left hand side