Filter
Top Products
26 – English
MAINTENANCE
Checking the cutting unit’s parallelism
Check the parallelism of the cutting unit as follows:
1. Place the machine on a level surface.
2. Measure the distance between the ground and
the front and rear edges of the cutting unit hood.
The cutting unit should slope forwards slightly so
that the rear edge is 2-4 mm higher than the
front edge.
Adjusting the parallelism of the cutting
unit
1. Remove the front hood and right-hand fender,
as described on page 18.
2. Undo the nuts on the lift strut.
3. Unscrew the strut (anticlockwise) to lower the
rear edge of the hood.
Screw the strut in (clockwise) to raise the rear
edge of the hood.
4. Tighten the nuts after adjustment.
5. On completion of the adjustment the unit’s
parallelism should be re-checked.
6. Fit the right-hand fender and the front hood.