Filter
Top Products
18 – English
Maintenance
3 If necessary, the wires can be adjusted by tightening the
adjuster nuts on each side of the steering collar. Do not
over tighten the cables; they should only be drawn in
towards the steering collar.
4 Unscrew the belt shields and the side protectors. The
protectors are fitted on both sides of the machine.
5 Hold the cable, for example using an adjustable wrench,
so that it does not twist. If the adjustment is only made on
one side, the middle position of the steering will be
affected.
6 Check the wire tension on completion of the adjustment
as per item 2.
7 Screw on the belt shields and the side protectors.
Remember to use the right screws in each mounting.
Adjusting the parking brake Rider
318
The parking brake is adjusted as follows:
1 Loosen the locking nuts (1).
2 Tension the cable using the adjuster screw (2) until the
play in the cable is taken up.
3 Tighten the locking nuts (1) after adjustment.
4 The parking brake should be checked again after the
adjustment has been made.
Adjusting the parking brake Rider
320 AWD
Check that the parking brake is adjusted correctly by placing
the machine on a slope with the front and rear axles
disengaged.
Apply and lock the parking brake. When the machine does not
stand still, the parking brake should be adjusted according to
the following.
1 Remove the left-hand wing cover.
2 Loosen the locking nuts (1).
3 Tension the cable using the adjuster screw (2) until the
play in the cable is taken up.
4 Tighten the locking nuts (1).
5 The brake should be checked again after adjustment
6 Assemble the left-hand wing cover.
Checking and adjusting of throttle
wire
The throttle cable may need to be adjusted, if the engine does
not respond as it should when accelerating, if it produces
black smoke or maximum revs are not reached.
If doubts arise, contact your service representative.
1 Loosen the clamping screw for the cable’s outer casing
and move the throttle to the full throttle position.
2 Pull the choke wire casing to the far right and tighten the
clamping screw.
!
WARNING! A poorly adjusted parking brake
can result in reduced braking ability.