Filter
Top Products
24 – English
MAINTENANCE
1. Fit the unit in the attachment frame’s outer
hooks.
The parts of the cutting unit
A cutting unit with a rear ejector has been used in
the instructions below, however, the same procedure
applies to other units if not otherwise stated.
The parts mentioned are:
A. Catch E. Height setting arm
B. Inner pin F. Parallelism arm
C. Hook guard G. Lowest height setting stop
D. Handle
2. Pull out the catch (A) and release the hook
guard by sliding its handle backwards.
3. Lift the attachment by pulling up the lever
located on the driver’s right-hand side.
Fitting the cutting unit
Starting point for fitting the unit:
• Place the Rider on a level surface.
• Apply the brakes by pressing down the pedal
and lock using the pushbutton.
• The attachment frame in the lowered position.
• The attachment frame locked with the hook
guard and the catch (A) in the loaded position.
A
A
B
C
D
F
E
G
A