Filter
Top Products
18 – English
DRIVING
Driving the machine
1. Release the parking brake by pressing down the
parking brake pedeal and then releasing it.
3. Select the required cutting height (1-9) with the
cutting height lever.
To obtain a uniform cutting height it is important
that the tyre pressures are equal on both front
wheels 60 kPa/8.5 PSI.
2
1
2. Carefully press down one of the pedals until the
correct speed is reached.
To drive forwards: press down pedal (1).
To reverse: press down pedal (2).
6017-012
6017-214A
6017-151
5. When the engine starts release the ignition key
immediately back to neutral position.
WARNING!
Never run the engine indoors, in
enclosed or poorly ventilated
areas. The exhaust fumes
contain toxic carbon monoxide.
6017-244
6017-245
6. Push the choke lever gradually forward when
the engine has started.
7. Set the required engine speed with the throttle
control.
Let the engine run at moderate speed or half
throttle for 3-5 minutes before subjecting it to
heavy load.
IMPORTANT INFORMATION
Do not run the starter for more than about
5 seconds at a time. If the engine does not
start, wait about 15 seconds before trying
again.