Filter
Top Products
14 – English
PRESENTATION
Seat
The seat has a jointed attachment on the front edge and can
be tipped forward.
The seat can also be adjusted lengthways.
To adjust move the lever under the front edge of the seat to
the left, so that the seat can be moved forward or backwards
to the required position.
The seat springing can be adjusted by moving the rubber
stops in their mountings on the underside of the seat. Place
both stops in the front, middle or rear.
Fueling
The engine runs on unleaded petrol with a minimum octane
rating of 87 (not mixed with oil). We recommend the use of
biodegradable alkylate petrol. (max. methanol 5%, max.
ethanol 10%, max. MTBE 15%)
Do not fill the tank completely, leave an expansion area of at
least 2.5 cm (1“).
Lights and power outlet
The lights are switched on and off using the power switch (1)
on the control panel.
A seat heater or mobile phone charger are examples of
articles that can be connected to the power socket (2).
The power outlet is switched on and off using power switch (3)
on the control panel.
The voltage is 12 V.
The power outlet is fuse protected by its own fuse, which is
located below the ignition switch.
Release lever
The release control must be pulled out in order for the
machine to be moved when the engine is shutoff.
Should you attempt to drive the machine with the clutch
controls pulled out it will not move. The drive on the axle is
disengaged when one of the controls is pulled out.
Pull the controls to the end positions, do not use an
intermediate position.
R 422 Ts AWD have one control for the front axle and one
control for the rear axle.
• Clutch control, rear axle
- Control drawn out, drive system disengaged.
- Control depressed, drive system engaged.
• Clutch control, front axle
The control is positioned on the inside of the left front
wheel.
- Rear control (pulled out), drive system disengaged.
- Front control (pushed in), drive system engaged.
!
WARNING! Petrol is highly inflammable.
Exercise care and refuel outdoors (see
safety instructions).
IMPORTANT!
Do not use the fuel tank as a support area.
2
1
IMPORTANT! Always drive the machine with both clutch
controls pressed in.
1
2
3