Filter
Top Products
4
–
English
INTR
ODUCTION
Dear Customer
,
Thank y
ou for choosing a Husqvarna Rider. Husqvarna Riders are built to a unique design with a front-mounted cutting unit and a
patented rear-wheel steering system. Riders are designed for maximum efficiency even in small or confined areas. The closely
grouped controls and pedal-operated hydrostatic transmission also contribute to the performance of this machine.
We hope you will find this operator’s manual very useful. By following its instructions (on operation, service, maintenance, etc.) you
will significantly extend the life of the machine and even its second-hand value.
When you sell your Rider, make sure you pass on the operator’s manual to the new owner.
The last chapter in the operator’s manual consists of a Service Journal. Make sure that all service work and repairs are recorded.
A well-documented service history reduces the costs of seasonal maintenance and influences the second-hand value of the
machine. Bring the operator’s manual with the Rider when bringing it to a workshop for service procedures.
Driving and transpor
t on public roads
Chec
k the relevant road traffic regulations before driving the machine on a public road. If transporting the machine on another
vehicle always use approved securing devices and make sure that the machine is securely held.
T
owing
When y
our machine is equipped with a hydrostatic transmission you should, if necessary, only tow the machine over short
distances and at a low speed, otherwise there is a risk of damaging the transmission.
The power transmission must be disengaged when towing, see the instructions under the heading Clutch control.
Use
This machine is designed solely f
or cutting grass on conventional lawns and other cleared and leveled ground without obstacles,
as rocks, stumps etc., and, in conjunction with accessories supplied by the manufacturer even for other special tasks for which
instructions are delivered with the accessory. Use in any other way is considered as contrary to the intended use. Compliance with
and strict adherence to the conditions of operation, service and repair as specified by the manufacturer also constitute essential
elements of the intended use.
This machine should be operated, serviced and repaired only by persons who are familiar with its particular characteristics and
who are acquainted with the relevant safety procedures.
Accident prevention regulations, all other generally recognised regulations on safety and occupational medicine, and all road traffic
regulations must be observed at all times.
Any arbitrary modifications carried out to this machine may relieve the manufacturer of liability for any resulting damage or injury.