Filter
Top Products
30 – English
Maintenance
Replacing the light bulbs
For information about the bulb type, see Technical Data.
1 Unscrew the two screws holding the cover on the power
servo housing.
2 Lift up the cover and turn it around the steering shaft.
3 Unscrew the two screws holding the lamp insert.
4 Lift out the lamp insert.
5 Disconnect the cables from the bulbs.
6 Lift out the bulbs from the insert.
7 Insert the new bulbs. Make sure you use your thumb to
support the front.
8 Refit the cables, lamp insert and the cover on the power
servo housing.
Main fuse
The main fuse is placed in a detachable holder under the
battery case’s cover, in front of the battery. Type: Flat pin, 15
A.
The fuse for the power outlet is placed under the ignition
switch, behind the side plate on the control panel. Type: Flat
pin, 7,5 A.
Do not use any other type of fuse when replacing.
A blown fuse is indicated by a burnt connector. Pull the fuse
from the holder when replacing.
The fuse is there to protect the electrical system. If it blows
again shortly after replacement, it is due to a short circuit,
which must be fixed before the machine can be put into
operation again.
Checking the tyre pressure
The tyre pressure should be 60 kPa (0.6 bar/8.5 PSI) all
round. To improve driving the pressure on the rear tyres can
be reduced to 40 kPa (0.4 bar/5.6 PSI). The maximum tyre
pressure is 100 kPa (1,0 bar/14 PSI).
IMPORTANT INFORMATION
Different tyre pressures on the front tyres will result in the
blades cutting the grass at different heights.