Filter
Top Products
8
ASSEMBLY
1. Position upper chute support against bagger inlet,
flush at outer edges. See Illustration.
2. Using support as a template, drill two
3
/8 holes into
bagger hood.
Upper Chute Support
Flex Trim
3. Secure upper chute support to hood with hex
bolts, washers and nyloc nuts.
7
CHUTE SUPPORT
NOTE: For ease of assembly, you may wish
assistance from another person for mounting
the cover assembly to mower.
1. Position cover assembly on ground behind
mower.
2. Lift and rotate cover to align the cover brackets
with support assembly tubes.
3. Slide the cover down over the support tubes until
secure.
Cover Assembly
8
COVER ASSEMBLY
9
MIDDLE CHUTE
1. Place middle chute over the top end of the blower
assembly, lining up the blower latch and the
acorn nut on the middle chute.
2. Stretch bungee latch up onto acorn nut to secure.
Middle Chute
Chute Latch