Filter
Top Products
English – 83
ASSEMBLY
Fitting the handlebar
Take care not to damage the cables and wires when you fold
up the handlebar.
Lift up the handlebar until the handlebar's upper tubular
construction comes directly opposite to the handlebar's lower
section. Tighten the knob correctly.
Dismantling and assembling the
cutter
The ignition lead should always be removed from the spark
plug before repair, cleaning or maintenance work.
Always empty the fuel tank before you place the lawn mower
on its side.
Dismantling
• Unscrew the bolt holding the cutter.
• Remove bolt, washer and cup spring.
• Remove the cutter.
Assembly
• Position the cutter so that the cutting edge faces in the
direction of rotation.
• Fit the cup spring, make sure it centres correctly on the
engine shaft.
• Fit the washer and tighten the bolt correctly. The bolt
should be tightened with a torque of 45-60 Nm.
Assembly of the catcher
• Lift the hind shield and suspend the grass container.
!
WARNING! Always wear heavy-duty gloves
when servicing and maintaining the cutting
equipment. The cutters are very sharp and
cuts can occur very easily.