Filter
Top Products
5
ASSEMBLY
BEFORE REMOVING TRAC TOR FROM
SKID
ATTACH STEERING WHEEL (See Fig. 1)
• Remove locknut and large flat wash er from steering
shaft.
• Position front wheels of the tractor so they are pointing
straight forward.
• Slide the steering sleeve over the steering shaft.
• Position steering wheel so cross bars are horizontal
(left to right) and slide onto steering wheel adapter.
• Secure steering wheel to steering shaft with locknut
and large flat wash er pre vi ous ly removed. Tight en
securely.
• Snap steering wheel insert into cen ter of steering
wheel.
• Remove protective materials from tractor hood and
grill.
IMPORTANT: CHECK FOR AND REMOVE ANY STAPLES IN
SKID THAT MAY PUNCTURE TIRES WHERE TRACTOR IS TO
ROLL OFF SKID.
FIG. 1
0312
6
BOLT
LARGE FLAT WASHER
STEERING
WHEEL
STEERING
SHAFT
STEERING
BOOT
STEERING
WHEEL
ADAPTOR
STEERING WHEEL
INSERT
LOCKWASHER
Your new tractor has been assembled at the factory with
the exception of those parts left unassembled for
shipping purposes.
TO REMOVE TRACTOR FROM
CAR TON
UNPACK CARTON
• Cut along dashed lines on all four panels of carton.
Remove end panels and lay side panels flat.
• Check for any additional loose parts or cartons and
remove.
When right or left hand is mentioned in this man ual, it means
when you are in the operating po si tion (seated be hind the
steer ing wheel).
(2) Keys
Slope Sheet
Key
(1) Oil Drain Tube
(1) Hood Scoop
(1) Hex Bolt
(1) Washer
(1) Seat
Steering
Wheel
Steering
Extension
Shaft
Steering Wheel
Adapter
Steering
Boot
Washer
Insert
(1) Hex Bolt
Lock Washer