Filter
Top Products
14 – English
MAINTENANCE
Blade disc assembly
Damaged blades should be replaced immediately.
Replacing or sharpening the blades should be conducted by
an authorised service workshop.
Changing the oil
The engine oil should be changed each year and every 25
working hours.
When changing the oil proceed as follows:
• Empty the fuel tank by running the machine until the tank
is empty.
• Disconnect the ignition lead from the spark plug.
• Unscrew the oil filler cap.
• Use the oil pump (accessory) to empty the oil tank.
Ask where you can dispose of surplus engine oil at your
local petrol station.
• Fill with new engine oil of a good quality. See the Technical
data section.
• Check the oil level with the dipstick on the oil filler cap.
• The oil filler cap must be completely screwed down to give
a correct picture of the oil level. If the oil level is low, fill
using engine oil up to the upper level on the dipstick.
• Screw on the oil filler cap.
Below you will find some general maintenance
instructions.
Daily maintenance
1 Check that the stop function works safely.
2 Brush leaves, grass and the like off of the lawn mower.
The underside of the mower deck should also be cleaned
after each use, to prevent a buildup of grass clippings.
3 Check the oil level.
4 Clean the air intake on the starter. Check the starter and
starter cord.
5 Check that nuts and screws are tight.
6 Check the cutting attachment. Never use blades that are
dull, cracked or damaged.
Weekly maintenance
1 Clean the air filter. Replace if necessary.
2 Clean the spark plug. Check that the electrode gap is 0.50
mm.
3 Clean the cooling fins on the cylinder.
At least once a year
1 Carry out annually service at authorised dealer (at least
once a year or every 30 hours).
!
WARNING! Always wear heavy-duty gloves
when repairing the blade disc assembly. The
blades are very sharp and can easily cause
cuts.
FU
L
L
D
O
D
O
NOT
NOT
OVE
R
F
ILL
OVE
R
F
ILL
CAUTION
CAUTION
FULLF
U
L
L
DOD
O
NONO
T
OVERFILL
V
ERF
IL
L
CACA
UTIONUTION
ST
OP
2
3
1