Filter
Top Products
4 SpeedMill
WARNING!
Before starting up machine make sure you
completely read these instructions and the
power cutter operation manual. Be familiar with
operation of the machine before operation!
Your SpeedMill comes with two Operator’s
Manual’s. This one for the SpeedMill attach-
ment and one for the K750 power head. It is the
owner’s responsibility to ensure that all opera-
tors of this SpeedMill have read and under-
stood the content of both manuals before using
the product.
Introduction
Thank you for purchasing your new machine from Husqvar-
na Construction Products. We have provided important
safety messages in this manual and on the machine.
Please read these messages carefully. A safety message
alerts you to potential hazards that could hurt you or others.
Each safety message is preceded by a symbol or the safety
alert symbol ( ) and one of two words, WARNING, or
CAUTION.
These signal words mean:
WARNING: Indicates a hazardous situation which, if not
avoided COULD result in death or serious injury.
CAUTION: Indicates a hazardous situation, which, if not
avoided, COULD result in minor or moderate injury. It may
also be used to alert against unsafe practices.
Each message tells you what the hazard is, what can hap-
pen, and what you can do to avoid or reduce injury.
NOTICE: Indicates a hazardous situation which, if not
avoided, COULD result in property damage. Your machine
or other property can be damaged if you don’t follow this
instruction.
If the label is worn, damaged, or is illegible, it should be
replaced.
Contents of Package
Verify the contents of the package:
• SpeedMill Power Cutter.
• SpeedMill Bowl Assembly: 100mm (4”), 150mm (6”), and
200mm (8”) Bowls with Hub and 2.00” Nut.
• Document Package. Operation Manual for Power Cut-
ter, Spare Parts List for Power Cutter, Operation Manual /
Spare Parts List for Speed Mill Accessory (This Document).
If these items are not included in the package, contact our
customer service department at the telephone number
shown in this document.
WARNING!
NEVER use a SpeedMill as a standard power cutter. A
SpeedMill is ONLY for USES listed in this document.
Cut only PVC plastic pipe with a machine equipped with
a SpeedMill Accessory! DO NOT cut other materials.
Use ONLY High Speed Reinforced Abrasive Blades with
this machine.
DO NOT use carbide tipped, wood cutting, or circular
saw blades with this machine.
DO NOT use diamond or rescue blades with this ma-
chine! Cutting plastics with a diamond or rescue blade
can cause kickback. The heat produced melts the
material and it sticks to the blade.
DO NOT cut ductile iron pipe with a SpeedMill.
DO NOT touch Bowl when machine is running. Speed-
Mill Bowl Rotates with Blade.
Before performing any maintenance, ALWAYS locate
the machine on a level surface with the engine / motor
OFF and the start switch in the OFF position, and the
power source disconnected.
EVACUATE PIPE CONTENTS before cutting; else EX-
PLOSION may occur. Static electricity from the cutting
operation may cause sewer or other gas within the pipe
to explode.
Safety Instructions:
SAFETY INSTRUCTIONS
The working area must be completely
clear, well lit and all safety hazards
removed.
Any persons not involved in the work,
should leave the area.