Filter
Top Products
6
LOWER CHUTE (See Fig. 4)
1. Raise and hold defl ector shield in upright position.
2. Place slot in lower chute over mounting tab on mower
and position lower chute over mower opening as
shown.
3. Hook rear latch into fl ange hole on back of mower.
4. Hook front latch into hole in front gauge wheel bracket
or under gauge wheel bracket on mower without a hole
in the bracket.
CAUTION: Do not remove defl ector
shield from mower. Raise and hold
shield when attaching lower chute
and allow it to rest on chute while in
operation.
4
CONTAINER MOUNTING (See Fig. 3)
1. Install one container to left side fi rst. Install another
container to center position and one in right position.
NOTE: Left edge of right con tainer should always over lap
right edge of left con tainer at center supports.
2. Close cover and lock latches over center support
tubes. To lock and release latches, pull back on latch
handles.
3
FIG. 3
03022
COVER LATCH
HANDLES
CONTAINER
HANDLES
CENTER
SUPPORT
TUBES
FIG. 4
02783
REAR LATCH
FRONT
LATCH
DEFLECTOR
SHIELD
MOUNTING
TAB
GAUGE WHEEL
BRACKET