Filter
Top Products
25
OPERATION
WARNING!
USE ONLY Blades (H) marked with a maximum operat-
ing speed greater than blade shaft speed of machine.
DO NOT change to a larger size blade without changing
to proper belts and pulleys!
DO NOT operate machine without proper guard over
Diamond Blade (H)!
DO NOT operate machine with Front Blade Guard (D)
raised!
Blade (H) exposure MUST NOT exceed 180 degrees
when operating machine!
Contact Surfaces of Blade Shaft Arbor (M), Inner Flange
(I), and Outer Flange (J) MUST BE clean and free of
foreign objects.
DO NOT not transport machine with Blade (H) installed.
DO NOT use conventional (wet) Diamond Blades (H)
without water.
READ operation instructions supplied with Blade (H).
DO NOT install Blade (H) unless power source is in
OFF (0) position, and dis-connected from power supply.
Fitting the Diamond Blade (H):
Install Diamond Blade (H) at job site. Do not
transport the machine with the Diamond Blade
(H) installed.
1. Open Front Cover (V).
2. Set Engine Start Switch (DD) to OFF (“0”) position.
3. Raise Diamond Blade (H) to highest position by turning
Blade Depth Control (EE) Counter-Clockwise.
4. Use 13mm Wrench (U) located in Tool Compartment
(BB), to loosen and remove four (4) M8 bolts that attach
Blade Guard Latch Plate (F). Temporarily remove Blade
Guard Latch Plate (F).
5. Raise Blade Guard Front (D).
6. Using the 27mm Blade Shaft Wrench (T), loosen and
remove the Blade Shaft Nut (L) that secures the Outer
Flange (J) in position.
NOTICE
Blade Shaft Nut (L1) on right hand side of machine has
left hand threads. To loosen, turn clockwise.
Blade Shaft Nut (L2)(not shown) on left hand side of
machine has right hand threads. To loosen, turn coun-
ter-clockwise.
NOTICE
Blade Shaft Nut (L1) on right hand side of machine has
left hand threads. To tighten, turn counter-clockwise.
Torque to 45 N•m (33 lb-ft) - minimum.
Blade Shaft Nut (L2)(not shown) on left hand side of
machine has right hand threads. To tighten, turn clock-
wise. Torque to 45 N•m (33 lb-ft) - minimum.
7. Remove Outer Flange (J).
8. Check that Blade Shaft Arbor (M), Inner Flange (I), and
Outer Flange (J) are clean and free of foreign objects.
9. Fit Diamond Blade (H) onto Blade Shaft Arbor (M). Di-
rection of rotation is shown by arrows on Diamond Blade
(H) and Blade Guard Front (D). See diagram at right.
10. Install Outer Flange (J) onto Blade Shaft Arbor (M).
Make sure that Locking Pin (K) passes through Diamond
Blade (H) and into Inner Flange (I).
11. Rotate Outer Flange (J) and Diamond Blade (H) in op-
posite direction of blade rotation to remove backlash.
12. Install Blade Shaft Nut (L). Tighten using 27mm Blade
Shaft Wrench (T).
13. Lower Blade Guard Front (D).
14. Re-install and tighten Blade Guard Latch Plate (F).