Filter
Top Products
English-44
MAINTENANCE
Heavy Duty Air Filter
If the engine seems weak or runs unevenly and the
dust load indicator has turned red the air lter may be
clogged. If run with a clogged air lter, disruption of
operation can occur.
Cleaning/replacing the air lter is carried out as
follows:
Only do so when the dust indicator is red.
WARNING!
The engine and the exhaust
system, become very hot during
operation. Risk for burns if
touched.
Allow engine and exhaust system
to cool at least two (2) minutes.
1. Unfasten the two metal clamps on the sides of the
air lter cover. Remove the air lter cover.
2. Remove the paper lter. Lightly brush or use mild
air pressure to clean.
IMPORTANT INFORMATION
Do not use compressed air to clean the air
lter.
Do not wash the paper lter.
Do not oil the paper lter.
Do not tap lter to clean this could cause
damage to the sealing.
3. Only remove and replace safety element after the
paper lter has been replaced 3 or 4 times.
4. Ret the air lter as follows:
Check that the seal on the bottom of the paper lter
is whole.
Mount the safety element in the air lter housing.
5. Place the paper lter over the safety element.
6. Replace the cover over the air lter housing.
Fasten the two metal clamps making sure the
cover is snapped into position.
7. Push top of dust load indicator to reset it.
8058-003
Heavy Duty Filter
8058-004
Cap Removal
8058-005
Outer element
8058-006
Inner element