Filter
Top Products
English-57
LUBRICATION
Deck Outer Spindle
Lubricate using a grease gun, one zerk, each side 2-3
strokes.
Use only good quality bearing grease.
Engine Oil
Changing the Engine Oil
The engine oil should be changed for the rst time
after 5-8 hours of operation. Thereafter, it should be
changed every 50 hours.
1. Place the machine on a at surface.
2. Place a container under the engine where the hose
from the oil drain valve exits.
3. Remove the dipstick and open the drain valve.
4. Allow the oil to run out into the container.
5. Then close the oil drain valve.
6. Replace the oil lter if necessary.
7. Fill with new engine oil in accordance with
Checking the Oil Level.
8. Start the engine. Run it for a few seconds. Stop
and recheck the oil level.
IMPORTANT INFORMATION
Used engine oil is a health hazard and
must not be disposed of on the ground or
in nature; it should always be disposed
of at a workshop or appropriate disposal
location.
Avoid skin contact; wash with soap and
water in case of spills.
WARNING!
Engine oil can be very hot
if it is drained directly after
stopping the engine. Allow
the engine to cool somewhat
rst.
Deck outer spindle
8011-733
Oil drain valve
8011-730