Filter
Top Products
OPERATION
33
Moving Machine by Hand
ZT-2800 Bypass Linkages
When pushing or pulling the mower, engage the
ZT-2800 bypass linkages. The ZT-2800 hydro release
levers are located on the rear of the frame, below the
rear engine guard.
1. Raise the deck into the highest cutting
position.
2. Pull the ZT-2800 release levers up and out of
the keyhole slots. Release the levers with the
head outside the frame and held in the bypass
position.
3. To re-engage the ZT-2800 to drive, reverse the
above procedure.
Load the machine into truck or trailer by driving up
ramps in low gear. DO NOT LIFT! The machine is not
intended to be lifted by hand.
8058-032
ZT-2800 engaged
8058-033
Bypass linkage, ZT-2800 locked in the bypass position
WARNING!
Use extreme caution when loading
the machine into a truck or trailer
using ramps. There is the possibility
of serious injury or death if the
machine falls off the ramps.
WARNING!
Make no adjustments without:
• the engine stopped,
• the ignition key removed,
• the parking brake activated