Filter
Top Products
CONTROLS
English-25
1. Foot pedal
2. Lift arm
3. Height plate
Cut height pedal
1
3
IMPORTANT INFORMATION
In order to obtain an even cutting height it
is important that the air pressure in all four
tires is the same 15 psi (1 bar).
IMPORTANT INFORMATION
Always use the high position to transport.
2
13. Cutting height pedal
The cutting deck height is obtained by pressing the foot
pedal lift arm forward and releasing the transport latch.
Then lower the deck to the preset height. To raise the
deck push forward on the foot pedal lift arm until the
transport latch locks. The cutting height range is from 1
1/2" (38 mm) to 4 1/2"
(114 mm) in 1/4" (6.4 mm) increments. The heights are
measured from the ground up to the blade tip with the
engine not running.
To change cutting heights move the pin on the cutting
height plates to the desired height of cut.
Accessories
For mulching, there is a BioClip attachment available.
This is mounted underneath the mower deck and
consists of control plates and BioClip blades.