Husqvarna 261 Chainsaw User Manual


 
English – 31
Muffler
The muffler is designed in
order to reduce the noise level
and to direct the exhaust
gases away from the operator.
The exhaust gases are hot and
can contain sparks, which may
cause fire if directed against
dry and combustible material.
Some mufflers are equipped
with special screens. If your
saw has this type of muffler,
you should clean the screens
at least once a week. This is
done with a wire brush.
Note! This muffler has a dual exhaust outlet and has
therefore also two screens.
CAUTION! The screens must be replaced, if damaged. The saw
will be overheated, if the screens are clogged. This results in
damage on the cylinder and the piston. Never use a saw with a
clogged or defective muffler.
Air filter
The air filter must be regularly cleaned from dust and dirt in
order to avoid:
Carburetor malfunctions
Starting problems
Engine power reduction
Unnecessary wear on
the engine parts
Abnormal fuel consumption
Clean the air filter daily or
more often if the air is
exceptionally dusty in the
working area.
Disassemble the air filter by
removing the cylinder cover
and unscrew the filter.
When reassembling, make
sure that the filter is tight
against the filter holder.
Clean the filter by brushing
or shaking it.
A more thorough cleaning of
the filter is obtained by
washing it in water and
soap.
An air filter, which is used for some time, cannot be cleaned
completely. Therefore it must be replaced by a new one, with
regular intervals. IMPORTANT! A damaged air filter must
always be replaced.
MAINTENANCE
Spark plug
The spark plug condition is
influenced by:
An incorrect carburetor
setting.
Wrong fuel mixture (too
much oil in the gasoline).
A dirty air filter.
These factors cause deposits
on the spark plug electrodes,
which may result in
malfunction and starting
difficulties.
If the engine is low on
power, difficult to start or
runs poorly at idling speed,
always check the spark plug
first. If the spark plug is dirty,
clean it and check the
electrode gap. Readjust if
necessary. The correct gap is
0,5 mm (0,020"). The spark
plug should be replaced after
about a month in operation or
earlier if the electrodes are
badly eroded.
IMPORTANT! Always use the recommended spark plug type.
An incorrect spark plug can severely damage the piston/
cylinder.
0,5 mm
Needle bearing maintenance
The clutch drum is equipped
with one of the following chain
sprockets:
Spur sprocket (A) (the chain
sprocket is welded on the
drum)
Rim sprocket (B)
(exchangeable)
Both versions have built-in
needle bearing at the drive
shaft, whitch has to be
greased regularly (once a
week).
NOTE! Use only high quality
bearing grease.
Adjustment of the oil pump
The oil pump is adjustable.
Adjustments are made by
turning the screw using a
screwdriver or combination
spanner. The saw is supplied
from the factory set to 1 turn
open. Turning the screw
clockwise will reduce the oil
flow and turning the screw
anti-clockwise will increase
the oil flow.
!
WARNING! The engine must not be running
when making adjustments.
Recommended settings:
Bar 11"-15": 0-2 turns from the closed position.
Bar 15"-18": 2-3 turns from the closed position.
B
A