Husqvarna CTH2036 Lawn Mower User Manual


 
25
SERVICE AND ADJUSTMENTS
TO REPLACE MOWER BLADE DRIVE BELT
(See Fig. 30)
Park the tractor on level surface. Engage parking brake.
BELT REMOVAL -
Remove mower from tractor (See “TO REMOVE
MOW ER” in this section of this manual).
Remove screws from RH mandrel cover and remove
cover.
Remove screws from LH mandrel cover and remove
cover.
Work belt off both mandrel pulleys and idler pulleys.
Pull belt away from mower.
BELT INSTALLATION -
Install new belt in reverse order of removal. See belt
routing decal located on right mandrel cover.
Make sure belt is in all pulley grooves and in side all
belt guides.
Install left and right mandrel covers and tighten se cure ly.
Make sure belt is in mandrel pulley cover.
Install mower (see "To install mower" in this section of
this manual).
LH MANDREL
COVER
BELT
MANDREL PULLEY
IDLER
PULLEY
RH MAN DREL COVER
MANDREL
PULLEY
IDLER
PULLEY
TO CHECK BRAKE
If tractor requires more than five (5) feet to stop at highest
speed in high est gear on a level, dry concrete or paved
surface, then brake must be serviced.
You may also check brake by:
1. Park tractor on a level, dry concrete or paved surface,
depress brake pedal all the way down and engage
parking brake.
2. Disengage transmission by placing freewheel control
in “transmission disengaged” position. Pull freewheel
control out and into the slot and release so it is held in
the disengaged position.
The rear wheels must lock and skid when you try to manu-
ally push the tractor forward. If the rear wheels rotate, then
the brake needs to be serviced. Contact a Sears or other
qualified service center.
FIG. 31