Husqvarna CRT900 Lawn Mower User Manual


 
15
SERVICE AND ADJUSTMENTS
CABLE CLIP
SCREW
DRIVE
CONTROL
CABLE
EXTENSION
SPRING
ENGINE
PULLEY
IDLER
PULLEY
TRANS MIS SION PULLEY
LESS
TEN SION
5/8"
MORE
TEN SION
TO REPLACE GROUND DRIVE BELT
(See Fig. 23)
Remove belt guard (See “TO REMOVE BELT GUARD”
in this section of this manual).
Remove old belt by slipping off engine pulley first then
remove from transmission pulley.
Place new belt in groove of transmission pulley and
into engine pulley. BELT MUST BE IN GROOVE ON
TOP OF IDLER PULLEY. NOTE POSITION OF BELT
TO GUIDES.
Check belt adjustment as described below.
Replace belt guard.
Reposition wheel and replace clevis pin and hairpin
clip.
Fig. 23
GROUND DRIVE BELT ADJUSTMENT
(See Fig. 23)
For proper belt tension, the extension spring should
have about 5/8 inch stretch when drive control bar is in
“EN GAGED” position. This tension can be attained as
follows:
Loosen cable clip screw securing the drive control
cable.
Slide cable forward for less tension and rearward for
more tension until about 5/8 inch stretch is obtained
while the drive control bar is engaged.
Tighten cable clip screw securely.