Husqvarna CD61B Lawn Mower User Manual


 
English-18
MAINTENANCE
8011-622
Slackening the belt tensioner
Deck belt
Deck belt removal
Park on a level surface. Apply park brake.Lower the
deck into the lowest cutting position.
Remove foot plate and belt shields.1.
Using a ratchet and socket on the spring idler 2.
bolt, relieve the tension on the belt.
Remove any dirt or grass that may have 3.
accumulated around the cutter housings and
entire deck surface.
Carefully roll the belt over the top of the cutter 4.
housing pulleys.
Remove the belt from around the electric clutch 5.
on the engine shaft and off the deck.
Deck belt installation
Wrap the deck belt around the electric clutch 1.
pulley that is located on the engine shaft.
Route the belt forward between and up onto 2.
the deck.
Place belt around spring loaded idler pulley.3.
Wrap the belt around the stationary idler pulley 4.
and around the mandrel housings.
Push inward on the idler arm and carefully 5.
route belt over stationary idler pulley. Once belt
is properly routed, slowly release idler arm to
tension belt.
Double check belt routing to make sure it 6.
matches the routing decal, and the belt does
not have any twist. Correct as needed.
Adjust tension.7.
Replace belt shields on both mandrel housings 8.
and secure with fasteners.
IMPORTANT INFORMATION
For ease in installing the deck belt, refer to
the routing decal on bottom of seat.