Filter
Top Products
English-22
TECHNICAL DATA
Torque Specifi cations
Engine crankshaft bolt 50 ft/lb (67 Nm)•
Deck pulley bolts 45 ft/lb (61 Nm)•
Lug nuts 75 ft/lb (100 Nm)•
Blade bolt 45-55 ft/lb (60-75 Nm)•
Standard ¼" fasteners 9 ft/lb (12 Nm)•
Standard •
5
/16" fasteners 18 ft/lb (25 Nm)
Standard •
3
/8" fasteners 33 ft/lb (44 Nm)
Standard •
7
/16" fasteners 52 ft/lb (70 Nm)
Standard ½" fasteners 80 ft/lb (110 Nm)•
When this product is worn out and no longer used, it should be returned to the reseller or other party for recycling.
In order to implement improvements, specifi cations and designs can be altered
without prior notifi cation.
Note that no legal demands can be placed based on the information contained in
these instructions.
Use only original parts for repairs. The use of other parts voids the warranty.
Do not modify or install non-standard equipment to the unit without consent from the
manufacturer. Modifi cations to the unit may cause unsafe operations or damage the
unit.
Conformity Certifi cates
USA requirements
Labels are placed on the engine and/or in the engine compartment stating that the machine will fulfi ll the
requirements. This is also applicable to special requirements for any of the states, (California emission rules etc.).
Do not remove any of these labels. Certifi cates can also be supplied with the machine at delivery or written in the
Engine manual. Take care of them as they are valuable documents.
CE requirements
Vibration data corresponding to Directive 2002/44/EC is given in the Technical Data Section.
The Declaration of Conformity is included in the literature packet.