Husqvarna 326C, 326L, 326LX-Series, 326LDX-Series Chainsaw User Manual


 
12 English
ASSEMBLY
Assembly of the trimmer head
!
WARNING!
Under no circumstances may the cutting
equipment be used without an approved
guard fitted. See the chapter
Technical
data
. If the wrong guard or a defective
guard is fitted this can cause serious
personal injury.
Assembling the loop handlebar
(326L, 326L
X
, 326LD
X
)
Assembling the loop handlebar
(326C)
Clip the loop handle onto
the shaft. Note that the
loop handle must be fitted
between the arrows on the
shaft.
Slide the spacer into the
slot in the loop handle.
326L
X-series
: Fit the nut,
knob and bolt. Do not
overtighten.
Now adjust the trimmer to
give a comfortable working
position. Tighten the bolt/
knob.
Position the handle on the
shaft. Note that the handle
must be mounted below
the arrow on the shaft.
Fit the bolt, securing plate
and wing nut as shown in
the diagram.
Tighten the wing nut.
It is extremely important that
the disc drives/support
flanges guide engages
correctly in the cutting
equipments centre hole
when assembling the cutting
equipment. Cutting
equipment assembled
incorrectly can result in
serious and/or fatal personal
injury.
Assembling and dismantling the
two-part shaft (326LD
X
)
Assembling:
Make sure the handle is
loose.
Guide the cut-out on the
lower section of the shaft
into the couplings
locking plate on the
upper section of the
shaft. The sections are
then locked together.
Tighten the handle.
Dismantling
Undo the handle (at least
three turns).
Press the handle towards
the coupling.
Carefully twist the lower
section out of the lock.
Hold both parts of the
shaft and pull out the
lower section from the
coupling.