Filter
Top Products
8
ASSEMBLY
SUPPORT POST (See Fig. 4)
Use Hardware - - GROUP "C"
CAUTION: Container support is spring
loaded and locked to the cover. Handle
cover assembly carefully so as not to
unlatch the cover from the container
support.
• Rotate cover assembly onto its side as shown.
• Assemble support post to container support with the
three (3) carriage bolts and locknuts. Tighten securely.
FIG. 5
END CAP
COVER ASSEMBLY
SUPPORT POST
MOUNTING
BRACKET
LANCED TABS
BRACKET
SUPPORT PIN
RETAINER
SPRING
4
MOUNTING TO TRACTOR (See Fig. 5)
Use Hardware - - GROUP "D"
NOTE: For ease of assembly, you may wish to obtain the
assistance of another person for mounting assembly to
tractor.
• Raise seat on tractor to allow assembly to be mounted.
• With cover closed, lift assembly and place support post
inside mounting bracket. Allow assembly to rest on
lanced tabs of mounting bracket.
• Line up holes in mounting bracket with holes in support
post and insert bracket support pin. Secure with retainer
spring.
• Unlatch and open cover.
• Install the three (3) tubing end caps onto container
support.
• Tap each end cap onto container support tubes to seat
securely.
5
CONTAINER ASSEMBLY (See Fig. 6)
No hardware required
• Place bottom half inside of top half, as shown.
• Place one foot inside bottom half and lift top half to meet
bottom half.
• Press halves tightly together while lifting top to lock into
place as shown.
IMPORTANT: BEFORE LOCKING THE TABS, HOOKED
EDGES ON BOTH HALVES MUST OVERLAP TO FORM
SEAL AS SHOWN IN INSET.
• Repeat for second container.
6
FIG. 4
LOCKNUTS
CARRIAGE
BOLTS
SUPPORT
POST