Filter
Top Products
40
LUBRICATION
Lubricating the Cables
If possible, grease both ends of the cable and move the controls to end stop positions when lubricating.
Refit the rubber covers on the cable after lubrication. Cables with sheaths will bind if they are not lubricated
regularly. If a cable binds, it can disrupt operation.
If a cable binds, remove the cable and hang it vertically. Lubricate it with thin engine oil until the oil begins
to escape from the bottom.
Tip: Fill a small plastic bag with oil and tape it so that it seals against the sheath and allow the cable to hang
vertically from the bag overnight. If you do not succeed in lubricating the cable, it must be replaced.
Lubricating in Accordance with the
Lubrication Schedule
1. Hydraulic System, Oil Level
The hydraulic oil and filter shall be replaced
every 300 hours, and at least once a year.
Contact an authorized service workshop.
Check the oil level in the hydraulic tank daily.
The level should be about 3/4"-1" below the
top of the tank.
Check connections, hoses, and tubes for
damage or leaks. Replace or repair if
doubtful.
Changing Oil and Filters
Oil and filter changes should be carried out
by an authorized service center.
2. Driver’s Seat
Tip the seat.
Lubricate the linked mount at the front using
an oil can.
Lubricate the lengthways adjustment
mechanism with the oil can.
Lubricate the lengthways adjustment runners
with the oil can.
8011-565
Checking the hydraulic oil
Lubricating the lengthways adjuster under the seat