Filter
Top Products
English-52
MAINTENANCE
Anti-scalp rollers
Anti-scalp rollers are properly adjusted when they are
just slightly off of the ground when the deck is at the
desired cutting height in the operating position. Anti-
scalp rollers then keep the deck in the proper position
to help prevent scalping in most terrain conditions.
IMPORTANT INFORMATION
Adjust Anti-scalp rollers with the mower
on a at level surface.
1. Adjust the deck to the desired cutting height (see
“TO ADJUST DECK CUTTING HEIGHT” in the
operation section of this manual).
2. Using a ¾" wrench and a
9
/16" wrench, remove the
nut and shoulder bolt from the anti-scalp roller.
3. Lower the anti-scalp roller to the ground, and raise
it up to the next highest hole.
4. Replace and tighten the nut and shoulder bolt.
5. Be sure to adjust all of the anti-scalp rollers to the
same position.
6. Be sure to readjust the anti-scalp rollers if the
cutting height is changed.
IMPORTANT INFORMATION
The anti-scalp rollers must not be used
for gauge wheels or the roller and deck
may be damaged.
CZ-9
Anti-scalp roller