Filter
Top Products
English-51
MAINTENANCE
Adjusting the Mower Deck
WARNING!
Blades are sharp. Protect your
hands with gloves and/or wrap
blades with a heavy cloth when
handling.
WARNING!
Before performing any service or adjustment checklist:
1. Engage the parking brake.
2. Place the Blade switch in the disengaged position.
3. Turn ignition switch to “OFF” position and remove the key.
4. Make sure the blades and all moving parts have completely stopped.
5. Disconnect the spark plug wire from all spark plugs and place the wire where
it cannot come in contact with the plug.
Check the tire pressure before adjustment of the
mover deck, refer to Checking Tire Pressures in this
section.
Faulty mower deck adjustment will cause uneven
mowing result.
Leveling
1. Position the mower on a level, preferably concrete,
surface.
2. Check the pressure in all four tires. See “ Technical
Data” .
3. Raise the mower on lengths of 2" x 4" placed
edgewise under the cutting deck from front to rear
(see diagram).
4. Lower the deck onto the 2" x 4"´s. The rear of the
deck is approximately ¼" deeper than the front.
This gives the deck a proper pitch front to back
when lowered onto the 2" x 4" guides.
5. Set cutting height to 4".
6. Adjust the four lower chain bolts so all slack is
removed from the chains.
7. Move the lifting lever and check that all the chains
are equally tensioned. If they are not, adjust the
appropriate lower chain bolt in its slot.
Cutting Height
1. Raise and secure the deck height lever to the
transport position (4½").
2. Position blade tip so it is straight forward.
3. Measure from the cutting edge of the blades to a
at level surface. The distance should be 4½"
(114 mm).
4. Drop and secure the lever at (for example) the 2"
cutting height. Measure as above. The distance
should be 2" (50 mm).
8011-601
Leveling the mower deck