Filter
Top Products
ASSEMBLY
CHECK THE TIRE PRESSURE
Correct tire pressure is important for best cutting
performance and proper straight-line tracking.
Check the tire pressure and adjust
accordingly. Refer to the
"SPECIFICATIONS" section in this
manual.
UTILITY BOX INSTALLATION
Place utility box onto factory preinstalled
brackets.
Insert clevis pins through holes in utility
box and brackets as shown.
Insert hairpins through holes in clevis
pins.
CHECKLIST
PLEASE REVIEW THE FOLLOWING
CHECKLIST
All assembly instructions have been
completed
No remaining loose parts in crate or
parts bag(s)
Seat is adjusted properly and securely
fastened
All tires are properly inflated
Check wiring. See that all connections
are still secure, and wires are properly
clamped.
Before driving the mower, be sure the
EZT(E-Series Zeroturn Transaxle)
bypass linkages are in the drive position.
Install tail gate into grooves in utility box,
until seated.
NOTE: No riders and weight limited to less than
50 Ibs.
CLEVIS PIN
\
HAIRPIN
COTTER
UTILITY BOX
WHILE LEARNING HOW TO USE
YOUR MOWER, PAY EXTRA
ATTENTION TO THE FOLLOWING
ITEMS:
Engine oil is at proper level
Fuel tank is filled with fresh, clean,
regular unleaded gasoline. Check your
engine manual for fuel requirements.
Become familiar with all controls - their
location and function. Operate them
before you start the engine.
Become familiar with unit operation on a
flat and level area with the mower deck
(blade PTO disengaged) shut off and
engine at idle speed or partial throttle.
Be sure the brake system is in a safe
operating condition. If adjustment is
needed see Service and Adjustment
section.
PREINSTALLED
FRONTBRACKET
REAR BRACKET
10