Filter
Top Products
35
MAINTENANCE
counter-clockwise on right) to pull brake
actuating arm (E) forward until firm
contact between brake shoes and drum
can be felt. Hold in this position.
4. Rotate clevis until clevis pin can just be
inserted thru clevis and brake lever with
pin resting against rear of the hole in
brake lever.
5. Remove clevis pin and rotate clevis two
(2) full turns toward rear to allow correct
clearance between brake shoes and
drum.
6. Temporarily reinstall clevis pin (do not
install cotter pin) to keep clevis from
turning and tighten jam nut.
7. Remove pin and repeat above procedure on
opposite side.
8. Reinstall clevis pins and secure with new
cotter pins.
9. Set brake lever rearward to fully engaged
position.
10. Adjust spring (G) to correct tension by
turning rear jam nut until spring
measures 1 1/8”.
Checking the Blades
In order to attain the best mowing effect, it is
important that the blades are well sharpened
and not damaged.
Bent or cracked blades or blades with large
nicks in shall be replaced.
Check the blade mounts.
Blades should be inspected if they have
experienced hard impacts such as stumps,
curbs or other obstacles. Let your service
center decide whether the blades can be
repaired/ground or must be replaced.
Cleaning and Washing
Regular cleaning and washing, especially
under the mower deck, will increase the
machine’s life span. Make it a habit to clean
the machine directly after use, before the dirt
sticks.
8011-604
Check the blades
IMPORTANT INFORMATION
The replacement or sharpening of blades
should be carried out by an authorized
service center.
8011-514
Cleaning