Husqvarna 968999211 / CZ48 Lawn Mower User Manual


 
7
ASSEMBLY
1
BAGGER SUPPORT ASSEMBLY
(See Figures 1A and 1B)
1. Remove rear engine guard by removing the
six bolts that attach the guard to the frame.
2. Attach hitch (Part No. 539108014) to the
frame using the same holes and same six
bolts that attached the rear engine guard.
*NOTE: If your unit does not have the holes or
slots on the fenders, you will need to mark and
drill them before continuing.
3. Using the hardware shown, attach the upper
arms of the hitch to the rear fenders of the
frame.
2
MOUNTING COVER ASSEMBLY TO
SUPPORT ASSEMBLY
(See Figure 2)
NOTE: For ease of assembly, you may wish to
obtain the assistance of another person for
mounting cover assembly to mower.
1. Position cover assembly on ground behind
mower as shown.
2. Lift and rotate cover to align cover brackets
with support assembly tubes.
3. Slide cover assembly down onto the support
tubes.
FIGURE 1A
FIGURE 1B FIGURE 2
ENGINE
GUARD
BOLTS
REAR ENGINE GUARD
ENGINE
GUARD
BOLTS
ENGINE
GUARD
BOLTS
HITCH
NUT, 5/16, NYLOC
3/8" HOLE
*
3/8" HOLE*
BOLT,
5/16-18 X 1 1/4
WASHER,
SPECIAL
WASHER, 5/16
COVER
ASSEMBLY
SUPPORT
ASSEMBLY
NUT, 5/16, NYLOC
WASHER, 5/16
WASHER, 5/16
WASHER,
SPECIAL
WASHER, 5/16
BOLT,
5/16-18 X 1 1/4
FENDER