Filter
Top Products
12
By moving the levers an equal amount forward
or back the machine will move in a straight line
in that direction. FIG - 11
Movement of either lever forward will cause the
right or left wheel to rotate in a forward direc-
tion. To stop movement pull both levers into the
neutral position.
To turn right while moving in a forward direction
pull the right lever back towards the neutral
position, this will slow the rotation of the right
wheel and cause the machine to turn in that
direction.
To turn left while moving in a forward direction
pull the left lever back towards the neutral
position, this will slow the rotation of the left
wheel and cause the machine to turn in that
direction.
To zero turn pull one lever back beyond neutral
while holding the other slightly ahead of neu-
tral. NOTE: The direction of the zero turn will
be determined by which lever is pulled back
beyond neutral. Thus left lever back, left zero
turn and opposite for right zero turn. Use extra
care when using this maneuver the machine
can spin very rapidly if one lever is posi-
tioned to far ahead of the other.
Blade engagement switch located on the
console is engaged by pulling up on the switch
and pushed down to disengage. FIG - 12
Choke control is located on the console. To
choke engine pull knob push to release. FIG -
12
Throttle control is located on the console. Used
to control engine RPM. FIG - 12
Parking brake is located on the left side of the
machine and directly in front of the fuel tank.
Pull the lever back to engage the brake and
push lever forward to release the brake.
Key switch is located on the console. Used to
start the machine. NOTE: Do not run the starter
for more than 5 seconds at a time. If the en-
gine will not start, wait about 10 seconds
before trying again. FIG - 12
OPERATING INSTRUCTIONS
Key Switch
Throttle
Choke
Blade
Engagement
Motion Control Lever Pattern
(Right Side)
FIG - 11
FIG - 12