Filter
Top Products
22
CONTROLS
Fuel Shut Off Valve
The fuel shut off valve is located at the left rear of the
seat. The valve is off when the handle tab is turned
perpendicular to the fuel line.
8011-419
Fuel shut off valve in the CLOSED position
Cutting Height Adjuster
To set the desired deck cutting height, press the
release button and move the lever forward to the
preset height pin and release the button. See Before
Starting in the Operation section to change the
cutting height. The cutting height range is from 1½"
(38mm) to 4" (102mm) in ½" (13mm) increments. The
heights are measured from the ground up to the blade
tip with the engine not running.
8058-019
The mower deck’s lifting lever
IMPORTANT INFORMATION
To obtain an even cutting height, it is
important that the air pressure in all tires is 15
psi / 103 kPa / 1 bar.
IMPORTANT INFORMATION
Always raise the deck to the highest position
for transport.
Bypass Linkages
The levers are located on each side of the rear of the
unit below the rear engine plate. The bypass linkage
is used when manually pushing or pulling the unit.
See Moving Machine By Hand in the Operation
section.
8058-0147
Left side bypass linkage
WARNING!
Bypass linkages are located close
to the muffler. To prevent burns, the
engine should be shut off and allowed
to cool before the bypass linkage
levers are handled.