Filter
Top Products
CONTROLS
23
1
2
Cutting Height Pedals
The cutting height pedals release the deck lift to allow
setting the desired deck height. Apply pressure to the
lift pedal and rotate foot to also apply pressure to the
release pedal, unlocking the deck lift.
For transport, push the lift pedal fully forward until the
deck lift latches in the transport (highest) position.
8065-017
1. Lift pedal
2. Release pedal
Cut height selection pedals
Tracking Knob
If the mower is not tracking straight, check the
air pressure in both rear tires. Recommended air
pressure for the rear tires is 15 psi (1 bar).
1. Tracking adjustments are made using the tracking
bolt and tracking knob. The tracking bolt and
tracking knob act as limiting devices for the
motion control levers when in the full-forward
position.
2. For preliminary tracking adjustment, move unit
to an open, unobstructed area such as an empty
parking lot or open field.
3. Back the tracking bolt out until flush with nut.
4. Loosen tracking knob out until flush with nut.
5. Test operate unit by driving it at full throttle and
the full forward position on both motion control
levers. Gradually turn in the tracking bolt on the
right hand side until the unit noticeably starts
drifting right.
6. Drive forward at full throttle with both motion
control levers in the full forward position.
Gradually turn in the tracking knob (left side) until
unit tracks straight.
8065-060
Tracking adjustment