Filter
Top Products
MAINTENANCE
48
2
1
Anti-scalp Rollers
Anti-scalp rollers keep the deck in the proper position
to help prevent scalping in most terrain conditions. Do
not adjust the rollers to support the deck.
IMPORTANT INFORMATION
Adjust anti-scalp rollers with the mower on a
flat level surface.
To avoid deck damage, the anti-scalp rollers
must not be adjusted to support the deck.
The anti-scalp rollers can be set in three positions:
• Upper position 1 to 2½" (25 to 63 mm) grass.
• Middle position 2½" to 4" (63 to 102 mm) grass.
• Lower position 4" to 5" (102 to 127 mm) grass.
8065-029
Anti-scalp rollers
8065-030
1. Caster bolt
2. Axle spacer
Caster wheel
Caster Wheels
Check every 200 hours. Check that wheels rotate
freely.
Removal and Installation
Remove nut and caster bolt. Pull the wheel out of
the fork. Install in reverse order. Tighten caster bolt.
Torque to 45 ft-lbs (61 Nm), then back nut off ½ turn.
NOTE: Tire should rotate freely but axle spacers
should not.
If wheels do not rotate freely take the unit to the dealer
for service.
8065-062
Deck lift spring
Deck Lift Spring
When mowing 2" or lower, it may be necessary to
adjust the deck lift springs. Access the springs by
tilting the seat forward.
Loosen the nut to adjust the spring tension.