Filter
Top Products
FERTILIZER
PARTICLE SIZE
BAG RATE
Lbs. of fertilizer used per
1,000 sq. ft. of coverage
APPROX.
SETTING
SPREAD
WIDTH
Large, heavy
particles
5
10
15
M
O
Q
12
12
12
Medium- mixed
particles
5
10
15
L
N
O
10
10
10
Small particles
(nitrogen)
1
2
3
G
J
L
10
10
10
Mixed size particles
-some fines
5
10
15
M
O
P
8
8
8
Light weight
particles
5
10
15
J
L
O
6
To
8
The following provides approximate 70 PP settings when only the product weight, square
The conversions should be used as guidelines for establishing proper rate settings for the particular product being
applied. Steps for obtaining the most accurate settings are outlined in the “How to Determine Spreader Settings and
Spread Width” section of this manual.
These settings are approximate and may vary due to physical characteristics of the product. Walking speed, wear,
condition of the turf and humidity, may cause actual rate setting to deviate. No expressed nor implied warranty or
guarantee is provided as to coverage or uniformity indicated by these rate settings.
1.
Never store unused material in spreader. Return
unused product to its original container.
2.
Wash spreader thoroughly after each use and dry
completely in sun or heated area.
3.
Grease axle bearings in frame. Oil the impeller shaft
bearing in hopper, pivot points on the shut-off plate
and the spring in the housing behind the rate plate.
4.
Remove gear cover and wash gears thoroughly. Oil
all bearing areas and face of gear teeth. Lubricate gear
teeth and re-install gear cover.
5.
Gear mesh should be checked on a regular basis
during high use periods. Clearance between the axle
gear and pinion gear should be minimal but not tight. If
adjustment is necessary, loosen axle collar set screw
and hold gears together. Slide axle collar against the
gear support and tighten axle collar set screw. Spin
drive wheel. Gears should run freely and smoothly.
6.
Impeller surface should be cleaned periodically to
remove build-up of product. Build-up can cause the
spread pattern to change.
7.
Tire pressure should be 20-25 PSI.
MAINTENANCE
MAINTENANCEMAINTENANCE
MAINTENANCE
Grease
Oil Bearing In
Hopper
Axle Collar
Oil
Oil
6
foot coverage, and visual inspection of the material is available.