Husqvarna 966004701 Blower User Manual


  Open as PDF
of 21
 
11
1. Position upper chute support against bagger inlet,
ushatouteredges.SeeIllustration.
2. Using support as a template, drill two
3
/8 holes into
bagger hood.
Upper Chute Support
Bagger Inlet
Nut
Bagger Hood
Flat Washers
Hex Bolt
Flex Trim
3. Secure upper chute support to hood with hex
bolts, washers and nyloc nuts.
ASSEMBLY
8
INSTALLING CHUTE SUPPORT
9
MOUNTING COVER ASSEMBLY
NOTE: Assistance from another person may ease
mounting the cover assembly to mower.
1. Liftandrotatecovertoalignthecoverbrackets
with support assembly tubes.
2. Slide the cover down over the support tubes until
secure.
10
INSTALLING SPACER PLUGS
Remove plastic end caps from the center two bag 1.
support arms. Fully insert spacer plugs into the
ends of the support tubes. It may be necessary
to tap the spacers into place with a hammer or
mallet.Replacetheplasticendcapbackoverthe
spacer. The additional extension will hold the hood
more securely when latched.
Remove center
end caps
Insert spacers
and replace caps
 previous next