Husqvarna 966004401 Blower User Manual


  Open as PDF
of 24
 
9
ASSEMBLY
1. Makesurethetensionreleaseleverisforwardor
disengaged.
2. Placethebeltoverthepulleyonthedeck.Referto
illustration for proper routing.
3. Move the tension release arm to the rear and
engage in the latch.
4
INSTALLING DRIVE BELT
RearOfDeck
Idler Pulleys
Outer Pulley
Twist in Belt
Tension Release Arm
5
INSTALLING BELT COVERS
1. Placethedeckbeltshieldonthedeckoverthe
drive pulley and secure with hardware removed
from steel belt shield.
2. Place retainer on the outer pulley cover.
3. Align the tab end of the belt cover into the slot on
thedeckbeltshieldandtheotherendovertheend
of the outer pulley cover.
4. Securewithknob.
Retainer
Knob
Outer Pulley Cover
DeckBeltShield
Belt Cover Tab
Middle Chute Latch
Temporarilysecuretheholddownbrackettothe1.
skidplate,usingaboltandnutfromthekitandthe
outerholeinthebracket.
If needed, prop the blower housing up so it sits
vertically level, but leave no more than an
1
/8" gap
betweenthedeckandblowerhousing.
SkidPlate
Back-upPlate
Back-upPlate
3
INSTALLING HOLD DOWN BRACKET
Usingtheback-upplateasatemplate,drillholes2.
in blower housing through the slots on the hold
downbracket.Drillinthemiddleofthebracket
slots to allow for adjustment if needed. Remove
holddownbracket.
Removeblowerhousing.Placeback-upplate3.
inside the blower housing, lining up new drill holes
andback-upplate.Installtheholddownbracketby
inserting bolts from the inside, through the blower
housingandintothebracketslots.Securewith
angenuts.
Hold Down
Bracket
Hold Down
BracketHole
 previous next