Filter
Top Products
Assembly Instructions cont’
Grassbox Assembly
1. Position the two grassbox halves together (D1)and press
each location point into position without
fully connecting the
clips.
2. When the location points are matched correctly firmly press
the grassbox together until all clips are securely connected.
(D2)
D1
D2
Cutting Height Adjustment
Cutting Height
The cutting height can be adjusted by removing the front
and back wheels on the product.
1. Remove the wheel by turning the wheel hub in an anti-
clockwise direction (E1) and relocate in new hole turn-
ing the wheel hub in a clockwise direction to tighten
(E2). Repeat for other wheels adjusting to the same
position.
POWERDRIVE VERSION
1. When the rear wheels are removed the height adjust-
ment holes can be viewed by moving the drive wheel
disc up and down,
E1 E2
Engine Notes
Oil
1. To fill with oil:-
a) Remove oil filter cap.
b) Fill to the FULL mark on the dipstick.
2. Use a good quality SAE 30 four stroke oil.
3. Check oil level periodically and after every five hours
of operation.
4. Add oil as necessary to keep the level to the FULL
mark on the dipstick.
5. Change the oil after the first five hours operation and
thereafter every 25 working hours.
6. Always change the oil while the engine is warm - but
not hot - never attempt any maintenance on a hot en-
gine.
Refer to the Engine Operators Manual for further infor-
mation.
Petrol
1. Use fresh regular grade lead free petrol.
2. NEVER USE LEADED PETROL
Using leaded petrol will make the exhaust smoke and
cause irreparable damage to engines fitted with a cat-
alytic converter.
3. Do not fill the fuel tank when the engine is hot.
4. Do not fill the fuel tank while smoking.
5. Do not fill the fuel tank while the engine is running.
6. To avoid introducing dirt into the fuel system, wipe all grass
and dirt from the petrol filler cap before unscrewing it.
7. It is recommended that you fill the tank through a fun-
nel with a filter.
8. Wipe away spillages before starting.