Filter
Top Products
5
ASSEMBLY
TO ASSEMBLE GRASS CATCHER
(See Fig. 3)
1. Put grass catcher frame into grass bag with rigid part
of bag on the bottom. Make sure the frame handle is
outside of the bag top.
2. Slip vinyl bindings over frame.
NOTE: If vinyl bindings are too stiff, hold them in warm water
for a few minutes. If bag gets wet, let it dry before using.
TO INSTALL ATTACHMENTS
Your lawn mower was shipped ready to be used as a
mulcher. To convert mower to bagging or discharging,
see “TO CON VERT MOWER” in the Operation section of
this man u al.
FIG. 3
FRAME
HANDLE
VINYL
BINDINGS
FRAME
OPENING
INSTALL STARTER ROPE (See Fig. 4)
1. Loosen T-knob.
2. Place throttle control in STOP position.
3. Slowly pull engine starter rope out until rope will slip
into loop of rope guide.
4. Tighten T-knob.
FIG. 4
THROTTLE CONTROL
“STOP” POSITION
ENGINE
STARTER
ROPE
ROPE GUIDE T-KNOB