Husqvarna 953900676 Brush Cutter User Manual


 
Engine will
Engine runs badly The machine
not start
or looses power runs but does
when cutting not cut well
••
••
••
The engine continues to have problems: contact your authorized supplier
Check STOP switch is in the position
I.
Control fuel level min. 25%tank
capacity.
Check air filter is clean.
Remove spark plug, dry it, clean it and
adjust it, and replace it, if necessary.
Change fuel filter. Contact your dealer.
Carefully follow the cutting accessory
assembly instructions.
Check metal cutting accessory is
sharp. Otherwise, contact your dealer.
normal lawnmower is unable to go.
Cutting and trimming grass borders with the
nylon string head
Cutting with the nylon string head is suitable for
light jobs like trimming borders and cutting the
grass around trees.
Mowing
To prevent damage to your lawn or the cutting
mechanism, keep the string parallel to the ground
but avoid contact with the terrain.
Trimming borders
Angle the nylon string head keeping it a short dis-
tance from the ground. Cut using the end of the
string. Do not press the string against the material
to be cut.
I1. Drawing out the string
During cutting, the nylon string wears naturally
causing an increase in the speed of the engine
and a reduced cutting capacity. When this hap-
pens, to bring out more string bump the head
against the ground: release the throttle trigger to
reduce the engine speed to less than 8000 rpm.
Tap gently on the ground with the button (A) as
shown in the figure and the string will come out
automatically. Accelerate again. If the string does
not come out make sure there is still some left
and try again.
I2. Thinning grass with the grass cutter blade
The grass is cut with swinging motions from side
to side, maintaining the blade parallel to the
ground. During the right to left swing the grass is
cut, while the backswing must be made without
using the blade.
KICKBACK can occur when cutting is done with
the risk sector of the blade; we recommend cutting
with the rest of the blade. Take care that the cup
supporting the blade just grazes the ground. This
will prevent the blade from touching the ground.
This section contains information useful for main-
taining the characteristics of eco-compatibility
included in the origin design of the machine, and
as regards proper use and disposal of oil and fuel.
Design
In the design stage, care was taken to develop an
engine with reduced consumption and low emis-
sions of noise and pollutant exhaust fumes.
Use of machine
The operations of filling the tank with the fuel mix-
ture should be carried out in such a way as to
avoid spilling fuel and contaminating the soil and
environment.
Periods of prolonged disuse
Always empty the fuel tank with the same precau-
tions used in filling it.
Disposal
Do not dispose inappropriately of the machine
when it is no longer usable. Deliver it to an
authorized organization for proper disposal in
compliance with the regulations in force.
L. Environmental information
ENGLISH - 8
2 16
M. Troubleshooting table