9
OPERATION
Choke control - used for starting a cold engine.
Traction drive control lever - used to engage power-pro-
pelled for ward or reverse motion of snow thrower.
LH and RH turn triggers - used to steer the snow thrower.
Defl ector remote control lever - used to change the
distance the snow is thrown.
Auger control lever - used to engage auger motion (throw
snow).
Discharge chute control lever - used to change the di-
rection the snow is thrown.
Skid plate - used to adjust height of scraper bar from the
ground.
Toolbox - used to store spare shear bolts, locknuts and
wrench.
Safety ignition key - must be inserted for the engine to
start and run. Remove when snow thrower is not in use.
Electric start button - used for starting the engine.
Recoil (auxiliary) starter handle - used for start ing en gine.
Primer - pumps additional fuel from the carburetor to the
cylinder for use when starting a cold engine.
Throttle/engine control - used to se lect either FAST or
SLOW engine speed and to STOP the engine.
Drive speed control lever - used to select forward or
reverse motion and speed of snow thrower.
MEETS A.N.S.I. SAFETY REQUIREMENTS
Our snow throwers conform to the standards of the American National Standards Institute.
FIG. 10
TRACTION
DRIVE
CONTROL
LEVER
DISCHARGE CHUTE CONTROL LEVER
DRIVE SPEED
CONTROL LEVER
AUGER
CONTROL
LEVER
MUFFLER
TOOLBOX
HANDLE
KNOB
SKID PLATE
CHUTE
DEFLECTOR
DISCHARGE
CHUTE
AUGERS
NOTE: ITEMS ABOVE
ARE SHOWN IN
THEIR TYPICAL
LOCATION ON THE
ENGINE. ACTUAL
LOCATION MAY VARY
WITH THE ENGINE
ON YOUR UNIT.
LIGHT
LH TURN
TRIGGER
CLEAN-OUT TOOL
DEFLECTOR REMOTE
CONTROL LEVER
RECOIL
(AUXILIARY)
STARTER
HANDLE
THROTTLE
/ ENGINE
CONTROL
MUFFLER
GASOLINE
FILLER CAP
SAFETY
IGNITION
KEY
CHOKE
CON-
TROL
ELECTRIC
START
BUTTON
PRIMER
FUEL
SHUT-OFF
VALVE