Filter
Top Products
SERVICE AND ADJUSTMENTS
CHECK TINE OPERATION
• See "TINE OPERATION CHECK" in this section of
manual.
REPLACE BELT GUARD
FORWARD MOTION (iNSiDE) V-BELT
ENGINE PULLEY
TRANSMISSION PULLEY
/ I _ \ BELT GUIDE
REVERSE
IDLER PULLEY
BELT GUIDE
FORWARD IDLER PULLEY
REVERSE (OUTSIDE) V-BELT
REVERSE
IDLER
PULLEY I /
\
ENGINE PULLEYX
FORWARD
iDLER PULLEY
belts 10
FRONT VIEW REFERENCE
REVERSE _ iDLER
ENGINE
Maintenance, repair, or replacement of the emission control
devices and systems, which are being done at the custom-
ers expense, may be performed by any non-road engine
repair establishment or individual. Warranty repairs must
be performed by an authorized engine manufacturer's
service outlet.
TO ADJUST CARBURETOR
The carburetor has been preset atthe factory and adjustment
should not be necessary. However, engine performance
can be affected by differences in fuel, temperature, altitude
or load. If the carburetor does need adjustment, contact
your nearest authorized service center/department
IMPORTANT: NEVER TAMPER WITH THE ENGINE
GOVERNOR, WHICH IS FACTORYSET FOR PROPER ENGINE
SPEED. OVERSPEEDINGTHE ENGINEABOVETHE FACTORY
HIGH SPEED SETTING CAN BE DANGEROUS. IFYOU THINK
THE ENGINE-GOVERNED HIGH SPEED NEEDS ADJUSTING,
CONTACTYOUR NEARESTAUTHORIZED SERVICE CENTER/
DEPARTMENT, WHICH HAS THE PROPER EQUIPMENT AND
EXPERIENCE TO MAKE ANY NECESSARY ADJUSTMENTS.
Fig. 21
REVERSE
IDLER PULLEY
IDLER
ARM
FORWARD
(iNSIDE) V=BELT
REVERSEIDLER ARM
REVERSE (OUTSIDE) V-BELT
BELT
GUARD
BOLT
ENGINE PULLEY
TRANSMISSION
PULLEY
BELT GUIDE FORWARD IDLER PULLEY
Fig. 22
15