Filter
Top Products
9
Check for a maximum line overlap of
one to two inches (four to five inches
of line extending from each eyelet).
Trim as required to final length.
7 8
9 10
11 12
E-Z Load
*2 required
PARTS LIST
1 Outer Housing
2 Adapter Bolt
3 Inner Spool
4 Outer Cover
5 Eyelets
6 Spring
7 Button/Knob
With line saver slots facing away from
you, wind the line clockwise on the
spool. Use a finger to keep the two
lines separate (spool shown is for
99909-017).
Lock the ends of the line in the line
saver slots in the spool.
Thread the ends of the line into the
eyelets in the housing. Do not allow
line to go under spool.
Replace the cover by aligning the
tabs, then snap the cover in place.
Pull line free from the line saver slots.
8 Retaining Ring
99909-017
Item Part No.
1 101134
2 102351
3 101030
4 101135
5* 105115
6 107001
7 101136
8 101137
99909-028
Item Part No.
1 101170
2 102349
3 101171
4 101172
5* 106007
6 107001
7 101136
8 101137
E-Z Pro
99909-018
Item Part No.
1 101134
2 102350
3 101030
4 101135
5* 105115
6 107001
7 101136
8 101137
99909-020
Item Part No.
1 101170
2 102350
3 101171
4 101172
5* 106007
6 107001
7 101136
8 101137
1" to 2"