Husqvarna 7021P Trimmer User Manual


 
12
MOWING
POSITION
MOWING
POSITION
HIGH POSITIONLOW POSITION
HANDLE
BRACKET
HAIRPIN
COTTER
MOUNTING
PIN
FIG. 15
LAWN MOWER
TO ADJUST CUTTING HEIGHT
See “TO ADJUST CUTTING HEIGHT” in the Operation
section of this manual.
REAR DEFLECTOR
The rear defl ector, attached between the rear wheels of
your mower, is provided to minimize the possibility that
objects will be thrown out of the rear of the mower into
the operator's mowing position. If the defl ector becomes
damaged, it should be replaced.
TO ADJUST HANDLE (See Figs. 14 thru 16)
The handle can be mounted in a high or low position. The
mounting holes in the bottom of lower handle are off center
for raising or lowering the handle.
1. Remove upper handle and all wire tie(s) securing
cable(s) to lower handle.
2. Remove hairpin cotters from lower handle bracket
mount ing pin.
3. Squeeze lower handle in to remove it from mounting
pins.
4. Turn lower handle over to raise or lower handle.
5. Squeeze lower handle in and po si tion holes onto
mount ing pins on handle bracket.
6. Reassemble upper handle and all parts removed from
lower handle.
CAUTION: TO AVOID SERIOUS INJURY,
BEFORE PERFORMING ANY SERVICE OR
ADJUSTMENTS:
ENGINE
Maintenance, re pair, or re place ment of the emission con-
trol de vic es and sys tems, which are be ing done at the
cus tom ers expense, may be performed by any non-road
engine repair es tab lish ment or individual. Warranty repairs
must be performed by an authorized engine man u fac tur er's
service outlet.
ENGINE SPEED
Your engine speed has been factory set. Do not attempt to
increase engine speed or it may result in personal injury. If
you believe that the engine is running too fast or too slow,
take your lawn mower to an authorized service center for
repair and adjustment.
CARBURETOR
Your carburetor is not adjustable. If your engine does not
operate properly due to suspected carburetor problems,
take your lawn mower to an authorized service center for
repair and/or adjustment.
IMPORTANT: NEVER TAMPER WITH THE ENGINE GOVERNOR,
WHICH IS FACTORY SET FOR PROPER ENGINE SPEED.
OVER SPEED ING THE ENGINE ABOVE THE FACTORY HIGH
SPEED SETTING CAN BE DANGEROUS. IF YOU THINK THE
ENGINE-GOVERNED HIGH SPEED NEEDS ADJUSTING,
CONTACT YOUR NEAREST AUTHORIZED SER VICE CEN TER,
WHICH HAS PROPER EQUIP MENT AND EXPERIENCE TO
MAKE ANY NEC ES SARY ADJUSTMENTS.
SERVICE AND ADJUSTMENTS
FIG. 14
LOWER HANDLE
HANDLE
BRACKET
HAIRPIN
COTTER
SQUEEZE
TO ADJUST
MOUNTING PIN
LOWER
HANDLE
ROTATE
FIG. 16
1. Release control bar and stop engine.
2. Make sure the blade and all moving parts have
completely stopped.
3. Disconnect spark plug wire from spark plug and
place where it cannot come in contact with plug.
CLEAN UNDER DRIVE COVER
Clean under drive cover at least twice a season. Scrape un-
derside of cover with putty knife or similar tool to remove any
build-up of trash or grass on underside of drive cover.