Filter
Top Products
5
TO INSTALL ATTACHMENTS
Your lawn mower was shipped ready to be used as a
mulcher. To convert to bagging or discharging; See "TO
CONVERT MOWER" in the operation section of this
manual
ASSEMBLY
MOWING POSITION
LIFT UP
LIFT UP
LOWER HANDLE
OPERATOR PRESENCE
CONTROL BAR
UPPER HANDLE
FIG. 1
Read these instructions and this manual in its entirety before
you attempt to assemble or operate your new lawn mower.
IMPORTANT: THIS LAWN MOWER IS SHIPPED WITH-
OUT OIL OR GASOLINE IN THE ENGINE.
Your new lawn mower has been assembled at the factory
with the exception of those parts left unassembled for
shipping purposes. All parts such as nuts, washers, bolts,
etc., necessary to complete the assembly have been placed
in the parts bag. To ensure safe and proper operation of your
lawn mower, all parts and hardware you assemble must be
tightened securely. Use the correct tools as necessary to
ensure proper tightness.
TO REMOVE LAWN MOWER FROM CARTON
1. Remove loose parts included with mower.
2. Cut down two end corners of carton and lay end panel
down flat.
3. Remove all packing materials except padding between
upper and lower handle and padding holding operator
presence control bar to upper handle.
4. Roll lawn mower out of carton and check carton thorougly
for additional loose parts.
HOW TO SET UP YOUR LAWN MOWER
TO UNFOLD HANDLE (See Fig 1)
IMPORTANT: Unfold handle carefully so as not to pinch or
damage control cables.
1. Raise handles until lower handle section locks into place
in mowing position.
2. Remove protective padding, raise upper handle section
into place on lower handle and tighten both handle
knobs.
3. Remove handle padding holding operator presence
control bar to upper handle.
Your lawn mower handle can be adjusted for your mowing
comfort. Refer to "Adjust Handle" in the Service and Adjust-
ments section of this manual.
CATCHER
FRAME
HANDLE
VINYL
BINDING
FRAME
OPENING
TO ASSEMBLE & ATTACH GRASS
CATCHER (See Figs. 2A & 2B)
1. Put grass catcher frame into grass bag with rigid part of
bag on the bottom. Make sure the frame handle is
outside of the bag top.
2. Slip vinyl bindings over frame.
NOTE: If vinyl bindings are too stiff, hold them in warm water
for a few minutes. If bag gets wet, let it dry before using.
3. Lift the rear door of the lawn mower and place the grass
catcher frame side hooks onto the door pivot pins.
4. The grass catcher is secured to the lawn mower housing
when the rear door is lowered onto the grass catcher
frame.
CAUTION: Do not run your lawn mower
without clipping deflector or approved
grass catcher in place. Never attempt to
operate the lawn mower with the rear
door removed or propped open.
FIG. 2A
FIG. 2B
PIVOT PINS
GRASS CATCHER
FRAME HANDLE
GRASS CATCHER
FRAME HOOK