Husqvarna 570, 575XP Chainsaw User Manual


 
40 – English
TECHNICAL DATA
Recommended original and replacement bar and chain combinations
Following is a list of recommended cutting equipment for Husqvarna chain saw models 575XP, 575XPG and 570. These chain saw
models equipped with either of the listed bar and sawchain combinations, fulfills the requirements according to ANSI B 175.1-2000
(Gasoline Powered Chain Saws - Safety Requirements).
Note: ATM (Armour Tip Medium) is a designation for a hard nose bar with nose radius 1,33”.
Bar Chain
Length, inch Pitch, inch Gauge, inch Max. nose radius Type Drive link count
16 3/8 0,058 11T sprocket or
ATM 1,33”
Husqvarna H42,
Husqvarna H48
60
18 3/8 0,058 68
20 3/8 0,058 72
24 3/8 0,058 84
28 3/8 0,058 92/93
32 3/8 0,058 105
16 3/8 0,050 Husqvarna H46,
Husqvarna H47,
Husqvarna H47S,
Husqvarna H82
60
18 3/8 0,050 68
20 3/8 0,050 72
24 3/8 0,050 84
28 3/8 0,050 93
32 3/8 0,050 105
!
WARNING! This chain saw is capable of
severe kickback that could result in serious
injury to the user. Do not operate this chain
saw unless you have extraordinary cutting
needs and experience and specialized
training for dealing with kickback. Chain
saws with significantly reduced kickback
potential are available.